48 volt dc 12 volt dc converter circuit diagram

The voltage it outputs during the discharge phase is proportional to the rate of change of current through it. When charged it stores energy and when discharged it behaves like an energy source. Diode D1 acts as a freewheeling diode.ДЄn inductor will always try to oppose any variation in the current passing through it and this property of the inductor is utilized here.

The fly back diode D2 will be forward biased and the energy stored in the inductor during the ON state will be dumped into the capacitor. When the output of oscillator goes low, transistor Q1 will be switched OFF and now the only path for the inductor current is through diode D2, capacitor C3 and the load if any. When the output of the oscillator stage is high, transistor Q1 will be switched ON and the current through the inductor L1 starts to increase. Output of the oscillator stage is connected to the base of transistor Q1 and resistor R7 is used for limiting the base current of Q1. Output of this comparator stage is fed to the non inverting input pin of IC1a through another 100K resistor. The output voltage is connected to the inverting input pin through a 100K resistor. Potential divider using preset R5 is connected to the non inverting pin of IC1. This is done for controlling the output voltage. IC1b is wired as a comparator which compares the output voltage with a reference and feeds back a voltage to the oscillator stage. Resistor R2 and capacitor C1 is used to set the oscillator frequency.

IC1a, resistors R1, R2, R3 and C1 forms a oscillator which operates at around 500Hz. LM324 is a quad opamp and out of the four operational amplifiers inside it, only two is used here. The circuit is basically aВ dc dc converter built around LM324 IC which is configured as an oscillator to produce the switching frequency and a transistor as the semiconductor switching element. This circuit can produce a steady 24C DC output and can deliver up to 800mA of output current. I found this circuit to be well enough for my application.

I also once faced a situation like this when I decided to fit a small transistorised stereo amplifier which operated from 24V DC in my car. There are many instances where we require 24V DC from a 12V source.

48 volt dc 12 volt dc converter circuit diagram